BEKOSPLIT
Emulsion treatment with a future
The BEKOSPLIT separates even stable emulsions and enables reliable and economical treatment of the resulting condensates. In this way, our emulsion splitting systems allow oil-contaminated compressor condensates to be disposed of free of pollutants.
Condensate separation is the solution whenever, because of its composition, treatment by purely physical gravity separation is not sufficient. This is generally the case with stable emulsions, which are often caused by mineral or synthetic compressor oils in the compressed air condensate.
Application
stable emulsions
Waste volume
less than 0.5%
Filtration
bag filter
Operation
fully automatic
Separating stable emulsions and treating difficult condensates
The BEKOSPLIT emulsion splitting system enables reliable, economical, on-site treatment of emulsified condensates that have formed due to unfavourable initial conditions or certain lubricant/compressor combinations. Water-insoluble organic contaminants such as oils and solid impurities are removed by adding a special reactive separating agent. The discharged water can then be fed into the sewer system free of pollutants. This is confirmed by the German Institute for Building Technology (DIBt).
BEKOSPLIT emulsion separation systems clean emulsified condensates that have formed due to unfavourable initial conditions or certain lubricant/compressor combinations. Water-insoluble organic substances and a wide range of solid impurities are removed from the water.
BEKOSPLIT® components in detail
Environmentally friendly reactive separating agents
We offer highly effective reactive separating agents – optimally matched to your application.
- highly effective reactive separating agent
- no aggressive cleaning agent required
- high clean-water quality
- legally compliant and cost-effective condensate treatment right where it arises
Filtration via
bag filter
High degree of dewatering thanks to the large filter surface. Filtration via bag filters reduces filter consumption, and the filter can be changed quickly and easily.
- drastic reduction of waste volumes to less than 0.5%
- easy to service
- easy filter removal thanks to bayonet lock
- easy filling of the dosing unit with reactive separating agent
Electronic
monitoring
The reactive separating agent supply and the filter are continuously monitored. Maintenance and fault messages can be processed externally via signal outputs.
- fully automatic operation
- operating status shown on display
- sensor-controlled level monitoring
- signal contact for maintenance and faults
Frequently asked questions
When do I need a BEKOSPLIT instead of an oil-water separator?
Whenever purely physical gravity separation is not sufficient. This is generally the case with stable emulsions, often caused by mineral or synthetic compressor oils.
How does emulsion splitting work?
A special reactive separating agent is added and removes oils and solid impurities from the condensate. The mixture is then filtered through a bag filter.
Can the cleaned water go into the sewer?
Yes. According to the manufacturer, the discharged water can be fed into the sewer system free of pollutants, as confirmed by the German Institute for Building Technology (DIBt).
How much waste is produced?
Filtration via bag filters reduces the waste volume to less than 0.5%.
How much maintenance is required?
Thanks to the bayonet lock, the filter can be removed quickly and easily, and the dosing unit is easy to fill with reactive separating agent.
How is the system monitored?
The reactive separating agent supply and the filter are continuously monitored electronically. The operating status appears on the display, and maintenance and fault messages can be passed on externally via a signal contact.
Which consumables do I need?
The reactive separating agent absorbs the oil and is disposed of once saturated. We offer two standard reactive separating agents and advise you on special solutions.
What sizes are available?
The series comprises the BEKOSPLIT 11, 12, 13, 14, 14S, 15 and 16.
Who helps me choose?
We do. We determine the composition of your condensate with you and select the right system and reactive separating agent. Call us or write to us.
BEKOSPLIT® consumables
As the reactive separating agent absorbs the bound oil from the condensate during the process, it eventually becomes saturated and can be disposed of. We offer you two different standard reactive separating agents. We will gladly advise you on the exact choice of special solutions.
